Our system is factory fabricated at our Wolverhampton facility. All of our experienced staff produce Swiftform to meet your exact site requirements.
We offer a free design service, all of the panels & sections will get to site on time ready to be put straight into the ground. One of our technical sales team will provide you with all the assistance you need and are more than happy to visit your site both before, during and after installation.
Our experienced staff produce Swiftform® to meet your exact site requirements. We offer a free design service, all of the panels & sections will get to site on time ready to be put straight into the ground.
One of our technical sales team will provide you with all the assistance you need and are more than happy to visit your site both before, during and after installation.
The product is processed in our factory, centrally located in the Midlands for distribution throughout the UK. Delivered direct to your site, ready for installation and is simple to install. The formwork is also environmentally friendly with no impact groundwater and is recyclable.
Swiftform® is a fast, cost-effective and convenient formwork material that you can rely upon. We recommend the product as an ideal solution to grade plate gripper spacers, plastic line spacers and concrete square bar. It can be supplied to site with appropriate rebar- cut/bent or prefabricated to suit.
The Benefits of Swiftform ®:
Tools – The only tools required are; Knife for cutting plastic, bolt croppers for cutting 5mm bar, knips for tying wire.
Accessories – Grade plate spacers 12 per M2 for sides or plastic line spacers at every 200 mm depth for sides and tying wire.
Joining – Laps are generally 100-200mm, at each joint it is advised that spacers are used over the joint, the joint can also be further secured using tying wire.
Corners – Corners can be supplied however it is very easy to create a corner by bending the 5mm bar and plastic by hand, (creating a corner from L section the 3mm bar on the toe needs to be cut where the corner is to be created)
Pile caps – All pile caps, bases and pads are specifically designed to suit. All supplied with drawings to suit appropriate kit of parts.
U Section – No blinding is required when using U section, it’s easy to cut around protruding piles using just a knife and knips.
L section – A toe generally 50mm is put on the bottom of the section. The toe can be put facing out to help secure when backfilling, or facing in if putting into a dug out trench.
Estimating – Swiftform® staff can produce a full take off of requirements, including the design of the pile caps. Take offs generally allow 10% extra for laps and corners and beams going in to pile caps, quantities are rounded up the nearest 2.4 metre panel. We can also estimate the quantity of accessories required.
Total Group is a leading British manufacturer of steel reinforcement and building supplies.
With 20 years of experience and more than 110 dedicated staff, we have the tools and know-how to help you get what you want at the right cost.
Total Group Piling Division
Tel: 01902 382060
Fax: 01902 366155
Total Construction Supplies Limited
Boundary Industrial Estate
Tel: 01902 624220
Fax: 01902 461852